Skip to main content

Clear the "Show source frames" selection when it no longer applies

"Show source frames in Library" selects the frames a stack was made from. If you look them over and go back to the Editor without changing anything, that selection stays behind in the Library. Clicking a different file then keeps the green button on "Stack selected images" instead of letting you edit that one file, and if you pick a different result in the Editor, the Library is still showing the first result's frames.

The plan:

  1. If you haven't changed that selection, it clears when you move to a different result in the Editor. Clicking a frame next to it just shows you that frame, so you can look around without losing it.
  2. Once you add or drop frames, it's yours, and it stays until you clear it.
  3. The note above the filmstrip gets a Clear button that takes off the frame numbers, and the selection too if you haven't changed it.
  4. Whenever two or more frames are selected, a "Clear selection [Esc]" button shows on the Library toolbar, so it's always clear how to let go of a selection.

Suggested by Claus G.

Status: In Progress2 comments

Log in to comment and vote

Comments2

  • Claus Giloi

    •

    Nov 20

    Regarding 2. - Conceivably saving the retouched result could also clear the selection, rationale being that it marks proceeding to the next library image. I just encountered this… trimmed stack, retouched, saved, returned to Library and had to manually clear the selection.

  • Claus Giloi

    •

    Nov 18

    In situations where the source frames selection is automatically cleared, you might consider also returning the film strip scroll position to the beginning, the rationale being that it was “show source frames” that moved it and both should be reset together.